[. . . ] 2), cooking vapours and odours are conveyed straight outside by a disposal duct which passes through the wall/ceiling. 3), the appliance must be connected to an ducting apparatus/motor which works on its own using the appliance as a union for the air to be scavenged. [. . . ] 8 (optional): Take the two brackets (S) out of the accessory bag together with the 8 screws provided. Fit the brackets to the wall unit being careful to position these correctly; for this operation use the 4 longer screws. At this point, secure the appliance to the brackets using the 4 shorter screws. Ducting version and version with an External motor: connect the flange of the hood with the air venting hole made previously in the wall/ceiling by means of an adequate tube. Make the electrical connection of the hood by means of the power supply cable. Assemble the anti-grease grille with the hood, inserting it obliquely (making the front side go upwards). Filtering version: connect a proper pipe to the flange of the hood so that the air is sent outside the pensile and sent back into the room. Make the electrical connection of the hood by means of the power supply cable. Set the fiber panel inside the anti-grease grille blocking it by means of the 2 supplied metal wires (F), as indicated in Fig. Assemble the anti-grease grille with the hood, inserting it obliquely (making the front side go upwards). [. . . ] - To change the rectangular halogen bulbs open the cover and remove the bulb without touching it with bare hands (Fig. To take off the glass, open the trolley pulling it frontwards; pull the glass towards the left (or the right) and lift one side upwards as it is indicated in the Fig. [. . . ]